Finishing Options

Use this dialog to force specific finishing options, instead of using finishing options that were set in the template's media and section options. This is only applied when producing output, it does not modify the original finishing options in either the section or the template.

• Ignore section level finishing: Check to override finishing options at the document level only.
• Section to edit: Use the drop-down to select which section to apply the options below. The Document level is also listed to edit document-level finishing.
• Options: Click the option button to bring up control options:
• Reload: Restores the current section's properties to the default values set in the template for this section.
• Reload All: Restores all section properties to the default values set in the template for each section.
• Apply finishing from: Displays a list of available sections. Clicking on a section name loads that section's properties into the current section to edit.
• Apply current finishing to all sections: Applies the current properties to all sections.
• Binding group:
• • Style: What type of binding to request on the printer. This includes Stapled, Glued, Stitched, etc.
  • Side: On which side the binding occurs, such as Bottom, Left, top, etc.
  • Location: The location of the binding, such as Saddle, Side, Corner, etc.
  • Angle: If the binding should be done horizontally, vertically, or at an angle.
  • Item count: [TBD]
  • Area: [TBD]
• Holemaking group:
• Number of holes: [TBD]
• Pattern Catalog ID: [TBD]