Imposition Options

The imposition options page sets the repetition, order, margins and marks for imposition in the output.

• Sheet Size group:
• Final Media Size: Use the drop-down to select the size of the media where the output is printed. The size of the media should be equivalent to the initial section size multiplied by the number of repetitions, added with the margins and spaces between the repetitions.
  If Custom media size is selected, enter the custom Width and Height values.
  
  The Sheet Size cannot be altered if a Cover Page was selected in the Booklet Options Page.
• Sheet Rotations: Select aspect ratio of media (Landscape or Portrait), or allow Connect to automatically determine the proper aspect ratio.
• Scale to fit: Modify the size of each repetition to fit within the final media size.
• Rotate final output Sheet 180 degrees (upside down): Select to flip the output upside down.
• Repetition group:
  Allows selection of how many sections are to be placed, both Horizontally and Vertically. This is the total number of items, not the number of additional items being placed.
  
  If Booklet Binding were selected, some of these settings will be determined by the options made within the Booklet Options Page and they cannot be altered here.
  
  
• Space Between group:
  Allows selection of the amount of blank space to add between each repetition.
• Order group:
  
  If Booklet Binding were selected, some of these settings will be determined by the options made within the Booklet Options Page and they cannot be altered here.
  
  
  • Page Order: Select in which direction to go when adding sections to the output:
    • Left to right, then top to bottom
    • Right to left, then top to bottom
    • Top to bottom, then left to right
    • Top to bottom, then right to left
  • Stack Depth: Enter a stack depth or use the arrows to increment or decrement.
  • Reverse Pages: Select this option to reverse the order of pages.
    This would print the final record on the first page and the first record on the last page.
  • Force simplex: Select this option to make the output Simplex, rather than the imposition default of Duplex.
    
• Bleed Margins group:
  • Top, Bottom, Left, Right: Enter the bleed margins for each side of the page.
• CropMarks group:
  • Type: Use the drop-down to select the type of crop marks to add to the page.
  • Offset: How much separation (if any) to leave between the vertical and horizontal corner markings.
  • Width: Select the width of the crop mark lines.
  • Length: Select the Length of the crop mark lines.