Inserter Options

The Inserter Options page allows the selection of a High Capacity Feeder (HCF) model. These machines are also commonly referred to as Inserters or Folder-Inserters.
The options available on this page are dependent upon the model selected.
The options selected on this page influence the position of the markings set on the next page: Mark Position Options.

• Model: Use the drop-down to select from any previously loaded Inserter model, or use the Browse button to select a HCF file to load a new Inserter model.
  An image representing the chosen folder-inserter is displayed under the list, along with the HCF file details.
• Options Group:
  The options available here are all Inserter dependent, and thus will change based upon the Inserter model selection.
  To see how the selected Inserter markings would look on the printed page, click the Next button to move to the Mark Position Options page, which has a preview of the page. You can move back and forward between these two pages until you are entirely satisfied with the selections made.
• Mark Configuration: Use the drop-down to select the type of markings to add. This selection basically equates to the amount of area the markings will take up on the printed page.
• Fold Type: Use the drop-down to select the type of fold to apply to the paper. This will impact upon where on the page the markings will be placed.
• Collation level: Select whether the markings will be made at Document level, or Document Set level.
• Print marks on back: Check to place the Inserter Marks on the rear of the page.
• Selective Inserts: If selective inserts are supported by the chosen Mark Configuration you can select what markings to include and whether those markings are to included based upon some conditional setting.
  For example, you could add a marking to the third page of a document by making the selection Conditional and then setting the Condition entry to "page.nr = 3".
• Clear Background Area Tab:
  • Clear Background Area Check box: Select to add a white background to the OMR, preventing background colors or elements interfering with the OMR Markings when they are read by the Inserter.
    
  • Margins:
    

    • Same for all sides Check box: Select to enable the Left margin selection to be used to set all sides, identically.

    • Left, top, right, bottom: Enter individual measurements for the margins on all sides of the OMR Mark.
      
• Custom OMR OptionsTab:
  • Custom OMR mark sizing: Check this box to select a Custom OMR size, if such is supported by the Mark Configuration chosen.
    If the box is checked, then select from any of the following measurements, or leave blank to use default values:
    
• Line length: Enter a value between 10.16mm and 20mm.
• Line thickness: Enter a value between 0.254mm and 0.63mm.
• Gap distance: Enter a millimeter value 2.91mm and 4.2mm.
• Draw hot spots: Debugging feature. Adds hot spots (red rectangles) around each OMR mark position in the generated output.
• Reverse mark order: Reverse the order of the OMR marks in the generated output. If selected, the following occurs:
  • Marks that normally print top to bottom would print bottom to top.
  • Marks that normally print bottom to top would print top to bottom.
  • Marks that normally print left to right would print right to left.
  • Marks that normally print right to left would print left to right.