Runtime parameters

Runtime parameters can pass values from an automation tool - PReS Workflow, usually - to a template, data mapping configuration or Job Creation Preset. The actual values of the parameters may be different from one time that a process runs to the next, which means the output could be different even when the same template, data mapping configuration and/or Job Creation Presets are used.

Runtime parameters first have to be defined in the template, data mapping configuration or Job Creation Preset, depending on where they are needed.
Next, the source of each runtime parameter value must be set in the automation tool used. E.g in PReS Workflow, it should be set in the Runtime Parameters section of the OL Connect task that uses the template, data mapping configuration or Job Creation Preset.

For more information about defining and accessing runtime parameters:

• In a template, see: Runtime parameters.
• In a data mapping configuration, see: Properties and runtime parameters.
• In a Job Creation Preset, see: Runtime Parameter Selection.